French lace at the front, polyurethane around the edge. The part people see is the part that has to be invisible — and the part that takes the wear is built to survive it.
Full lace looks perfect and tears in three months. Full skin is tough and reads like a helmet at the hairline. We split the difference by putting each material where it actually earns its keep.
The front two inches are fine mesh with individually knotted, bleached hair. Nothing sits between your skin and the light, so the hairline disappears. This is the only zone anyone looks at closely.
Everything behind and around the front is thin poly. It holds tape and liquid adhesive properly, cleans in minutes, and doesn't fray when you re-attach every week. This is the zone that takes the abuse.
Full lace averages two to four months. Full skin reads wrong at the front. A hybrid gets you the invisible edge and a base that survives daily handling, at roughly half the annual replacement cost.
| Model | MS-H01 |
|---|---|
| Base construction | French lace front (approx. 2 in depth) + polyurethane perimeter |
| Base size | 7 × 9 inch (standard) / 6 × 8 inch — trimmable at the edges |
| Hair | 100% human hair (Indian remy), straight with a light natural wave |
| Hair length | 6 inch, cut and styled to preference |
| Density | 100% (light-medium). Deliberately not heavy — over-dense systems read as a hairpiece from across a room. |
| Hairline | Bleached knots, pre-plucked, graduated front density |
| Colors | 1B natural black · 2 dark brown · 1B40 black with 40% gray |
| Attachment | Tape (perimeter) + liquid adhesive (front hairline). Both included. |
| Expected lifespan | 4–6 months with normal care and weekly re-attachment |
| Care | Wash with sulfate-free shampoo. Use adhesive remover — never peel a bonded base off dry. |
| Property | Full lace | Full skin | MS-H01 hybrid |
|---|---|---|---|
| Hairline realism | Best | Weak, shines | Lace-level at front |
| Durability | 2–4 months, frays | 3–6 months | 4–6 months |
| Breathability | Best | Poor | Good at front, sealed at edge |
| Weekly re-attach | Fragile, high risk | Easy | Easy — poly takes the tape |
| Beginner friendly | No | Yes | Yes |
| Reads as a piece? | No | Sometimes | No |
The single most common reason a system looks wrong is size, not material. Measure the bare area of loss with a soft tape, front to back, then side to side.
Start where your hairline should sit and measure straight back to where loss ends. Most men land between 7 and 9 inches.
Measure the widest point across the loss area, ear to ear. This is usually 6 to 8 inches.
Order the next size up. The edges of every MS-H01 can be trimmed with scissors once it arrives — you cannot add material back.
Wet, light leave-in conditioner, comb. The hair gets no oil from your scalp, so it dries faster and needs conditioning more often than your own hair did.
Remove with adhesive remover, clean the base, wash and exfoliate the scalp, let both dry fully, re-tape. Skipping the dry step is how people get rash and how systems fail early.
Lifting a bonded base without solvent is the single fastest way to tear it. This is the one rule that matters more than everything else on this page.
If it doesn't match, send it back within 30 days. If it does, you'll know inside the first week.